Onsite installation of heat-shrink fluoropolymer roll covers.
A Fluoron technician installs FEP, PFA, PTFE, or conductive PTFE heat-shrink covers at your line, during a planned outage. The roll never leaves the plant.
When onsite install is the right path
Large or fixed-position rolls
Big-diameter or installed-in-line rolls that can’t be removed economically. The cost of crane time and rigging exceeds the cost of travel.
Short outage windows
A planned outage is too short to ship the roll, rebuild it, and ship it back. Onsite install lands inside the outage and the line is ready when production resumes.
Maintenance team training
The plant wants to install future covers in-house. The first install happens onsite with the plant’s maintenance team working alongside the Fluoron technician.
The onsite install timeline
- Week 1 — Intake & spec. You send the roll position, diameter, face length, line speed, service temperature, and the failure pattern via the Fluoron Spec tool.
- Week 2 — Sleeve fabrication. The fluoropolymer sleeve is cut and prepared at the Fluoron shop.
- Week 3 — Onsite logistics. Outage date is locked, lockout-tagout coordinated with plant maintenance, staging area confirmed, travel arranged.
- Week 4 or your outage week — Install day. Roll is locked out and at room temperature. The sleeve is recovered onto the roll body using the controlled-heat process — typically 2 to 6 hours of torch time.
- Week 5 — Follow-up. First production run after install is monitored remotely. Fluoron documents the install and provides cleaning and maintenance recommendations.
What makes Fluoron onsite installation different
- One install method across all four product families. FEP, PFA, PTFE, or conductive PTFE — same controlled-heat recovery process.
- Same-day or next-morning re-start. Onsite installs are scoped to land inside your existing outage window.
- No shipping risk. Large rolls don’t move. Crane time and freight cost are eliminated.
- Plant-side runout verification. The cover is checked under your installed alignment and bearings before the line restarts.
- Documented install for warranty and audit. Each onsite install ships with a documented procedure record, photos, and post-install measurements.
Onsite roll cover installation — common questions
Onsite install makes sense when shipping the roll is impractical or expensive, the line outage is short, or the customer wants to learn the install for future covers.
Installs typically take 2–6 hours per roll once setup is complete. Plant prep usually takes another 1–2 hours.
The fluoropolymer sleeve, propane / industrial torches and shrink-tooling, surface prep abrasives if needed, and full PPE.
All four heat-shrink families: Fluoro-Clear (FEP), Fluoro-Flex (PFA), Fluoro-Wear (PTFE), and Fluoro-Stat (conductive PTFE).
Yes. The roll must be out of service, at room temperature, and the line locked out.
Yes — customer install training is one of Fluoron’s three install paths.
Schedule an onsite install for your line
Send the roll position, dimensions, line speed, service temperature, and the failure pattern through the Fluoron Spec tool.